Conducting Foams & Plastics


content.gif (1503 bytes)
 Code Number :   5D10.25?

Disclaimer:

Reprinted by permission of Dick Berg, University of Maryland, for use on this website.

The demonstrations contained and referenced herein are listed for the purposes of cataloging and describing physics demonstrations which should be conducted only under the direction of a trained instructional support professional or physicist. These demonstrations are not presented for the purpose of being conducted by persons unconnected to this Facility and/or persons not consulting with or being supervised by the recognized instructional support professional or physicist and his/her staff. The University is responsible only for those demonstrations carried out using its own equipment using established safety and scheduling policies, and bears no responsibility for those choosing to use this source material for their own purposes. All demonstrations described and contained herein are public domain, and can also be found in reference materials in libraries, bookstores, and electronic sources.

Further information regarding legal liability in use of demonstrations and labs will be found on the web site Injuries in School/College Laboratories in USA.

The University of Iowa Disclaimers:  University of Iowa Disclaimer All Rights Reserved..

Condition :   Excellent  
Principle :   Conductivity  
Area of Study :  Chemistry and Physics  
Equipment :   Conducting foam or plastic, 3 volt battery pack, red LED.  

Procedure :   Plug the uncovered leg of the LED down through the conducting foam.  Insert the positive lead of the battery into the foam about 1 inch away from the LED.  The LED should light very dimly, but get brighter as you move the two leads closer together in the foam. 
conbot.gif (53 bytes)


   References

 

 



Mail Questions and Comments to:  Dale Stille