Burn a Resistor

Image #2

content.gif (1503 bytes)
 Code Number :   5D10.60?  

Disclaimer:

Reprinted by permission of Dick Berg, University of Maryland, for use on this website.

The demonstrations contained and referenced herein are listed for the purposes of cataloging and describing physics demonstrations which should be conducted only under the direction of a trained instructional support professional or physicist. These demonstrations are not presented for the purpose of being conducted by persons unconnected to this Facility and/or persons not consulting with or being supervised by the recognized instructional support professional or physicist and his/her staff. The University is responsible only for those demonstrations carried out using its own equipment using established safety and scheduling policies, and bears no responsibility for those choosing to use this source material for their own purposes. All demonstrations described and contained herein are public domain, and can also be found in reference materials in libraries, bookstores, and electronic sources.

Further information regarding legal liability in use of demonstrations and labs will be found on the web site Injuries in School/College Laboratories in USA.

The University of Iowa Disclaimers:  University of Iowa Disclaimer All Rights Reserved..

Condition :   Excellent  
Principle :   Ohms Law  
Area of Study :  Electricity and Magnetism   
Equipment :   Resistors (22 and 2200 Ohm), Small Holder Boards, Variac with On/Off Switch, Voltmeter (if desired).

  
Procedure :   Connect the resistor directly to a Variac with an on/off switch. Turn on the Variac and turn up the voltage until the 22 ohm resistor bursts into flames. Turn off the Variac leaving the voltage setting where it is. Insert a 2200 ohm resistor. Turn on the Variac and observe that this resistor will handle this voltage without damage. Increase the voltage and burn this resistor if you desire noting the additional voltage increase needed.  

The burnt out oven coil is an example of a terminal "increasing resistance / increasing temperature" cycle.

conbot.gif (53 bytes)


   References



Mail Questions and Comments to:  Dale Stille