Conductivity of Glass



Image #2

content.gif (1503 bytes)
 Code Number :   5D20.60  

Disclaimer:

Reprinted by permission of Dick Berg, University of Maryland, for use on this website.

The demonstrations contained and referenced herein are listed for the purposes of cataloging and describing physics demonstrations which should be conducted only under the direction of a trained instructional support professional or physicist. These demonstrations are not presented for the purpose of being conducted by persons unconnected to this Facility and/or persons not consulting with or being supervised by the recognized instructional support professional or physicist and his/her staff. The University is responsible only for those demonstrations carried out using its own equipment using established safety and scheduling policies, and bears no responsibility for those choosing to use this source material for their own purposes. All demonstrations described and contained herein are public domain, and can also be found in reference materials in libraries, bookstores, and electronic sources.

Further information regarding legal liability in use of demonstrations and labs will be found on the web site Injuries in School/College Laboratories in USA.

The University of Iowa Disclaimers:  University of Iowa Disclaimer All Rights Reserved..

Condition :   Excellent   
Principle :   Electrical conductivity  
Area of Study :  Electricity & Magnetism  
Equipment :   Two 25 Watt bulbs in sockets, variac, propane torch, hammer, baggie, wire cutters.
  
Procedure :   Hook the two 25 W bulbs in series to the variac and turn on so that the bulbs visibly glow.  Shut the variac off and unscrew one of the bulbs.  Place the bulb in a baggie and gently break the envelope with a hammer.  Take care not to damage the inner glass stem.  Clip off the filament as close to the glass stem as possible.  Screw back into the socket.  Turn on the variac.  The circuit should show no conduction (the undamaged light should remain off).  Light the propane torch and heat the glass stem.  When the stem starts to glow orange conduction should start to occur and be semi self sustaining (the undamaged 25 W bulb will start to glow).  When the glass stem cools conduction will stop.
conbot.gif (53 bytes)


   References



Mail Questions and Comments to:  Dale Stille